ATGE(4D) | Devices | ATGE(4D) |
atge - Device driver for Atheros/Attansic Ethernet chipsets
The atge ethernet driver supports the Atheros/Attansic L1, L1E, and L1C Ethernet (AR8121/AR8113/8114, AR8131/AR8132, and AR8151/AR8152) chipsets:
pciex1969,1026 Atheros AR8121/8113/8114 pciex1969,1048 Attansic L1 pciex1969,1062 Atheros AR8132 Fast Ethernet pciex1969,1063 Atheros AR8131 Gigabit Ethernet pciex1969,1073 Atheros AR8151 v1.0 Gigabit Ethernet pciex1969,1083 Atheros AR8151 v2.0 Gigabit Ethernet pciex1969,2060 Atheros AR8152 v1.1 Fast Ethernet pciex1969,2062 Atheros AR8152 v2.0 Fast Ethernet
The atge driver supports IEEE 802.3 auto-negotiation, flow control and VLAN tagging.
The default configuration is auto-negotiation with bi-directional flow control. The advertised capabilities for auto-negotiation are based on the capabilities of the PHY.
You can set the capabilities advertised by the atge controlled device using dladm(8). The driver supports only those parameters which begin with en (enabled) in the parameters listed by the command dladm(8). Each of these boolean parameters determines if the device advertises that mode of operation when the hardware supports it.
/dev/atge
/kernel/drv/atge
/kernel/drv/amd64/atge
See attributes(7) for a description of the following attribute:
ATTRIBUTE TYPE | ATTRIBUTE VALUE |
Architecture | SPARC, x86 |
streamio(4I), dlpi(4P), driver.conf(5), attributes(7), ieee802.3(7), dladm(8), ndd(8), netstat(8)
Writing Device Drivers
Network Interface Guide
STREAMS Programmer's Guide
IEEE 802.3ae Specification, 2002
September 11, 2009 | OmniOS |