yge - Marvell Yukon 2 Ethernet device driver
The yge driver supports Marvell Yukon 2 Fast Ethernet and
Gigabit Ethernet controllers.
The following properties can be configured using
dladm(8):
adv_autoneg_cap
Enables (default) or disables IEEE 802.3 auto-negotiation
of link speed and duplex settings. If enabled, the device negotiates among the
supported (and configured, see below) link options with the link partner. If
disabled, at least one of the link options below must be specified. The driver
selects the first enabled link option according to the IEEE 802.3 specified
preferences.
adv_1000fdx_cap
Enables the 1000 Mbps full-duplex link option.
adv_1000hdx_cap
Enables the 1000 Mbps half-duplex link option.
adv_100T4_cap
Enables the 100 BaseT4 link option. (Note that most
hardware does not support this unusual link style. Also, this uses two pairs
of wires for data, rather than one.)
adv_100fdx_cap
Enables the 1000 Mbps full-duplex link option.
adv_100hdx_cap
Enables the 1000 Mbps half-duplex link option.
adv_10fdx_cap
Enables the 10 Base-T full-duplex link option.
adv_10hdx_cap
Enables the 10 Base-T half-duplex link option.
mtu
On most devices, can be set between 1500 (default) and
9000. This property can only be changed when the device is not in use.
/dev/net/yge
Special network device
/kernel/drv/yge
32-bit driver binary (x86)
/kernel/drv/amd64/yge
64-bit driver binary (x86)
/kernel/drv/sparcv9/yge
64-bit driver binary (SPARC)
See attributes(7) for a descriptions of the following
attributes:
| ATTRIBUTE
TYPE |
ATTRIBUTE VALUE |
| Architecture |
x86, SPARC |
| Interface Stability |
Committed |