NTXN(4D) Devices NTXN(4D)

ntxn - NetXen 10/1 Gigabit Ethernet network driver

/dev/ntxn*

The ntxn 10/1 Gigabit Ethernet driver is a multi-threaded, loadable, clonable, GLD-based STREAMS driver supporting the Data Link Provider Interface, dlpi(4P), on NetXen 10/1 Gigabit Ethernet controllers.

The ntxn driver functions include chip initialization, frames transmit and receive, promiscuous and multicast support, TCP and UDP checksum off-load (IPv4) and 9600 bytes jumbo frame.

The ntxn driver and hardware support the 10GBASE CX4, 10GBASE-SR/W, LR/W, and 10/100/1000BASE-T physical layers.

The cloning character-special device, /dev/ntxn, is used to access all NetXen devices installed within the system.

The ntxn driver is managed by the dladm(8) command line utility, which allows VLANs to be defined on top of ntxn instances and for ntxn instances to be aggregated. See dladm(8) for more details.

The values returned by the driver in the DL_INFO_ACK primitive in response to your DL_INFO_REQ are:

Maximum SDU is 9600.
Minimum SDU is 0.
DLSAP address length is 8.
MAC type is DL_ETHER.
SAP (Service Access Point) length value is -2, meaning the physical address component is followed immediately by a 2-byte SAP component within the DLSAP address.
Broadcast address value is the Ethernet/IEEE broadcast address (FF:FF:FF:FF:FF:FF).

By default, the ntxn driver works without any configuration file.

/dev/ntxn*

Special character device.

/kernel/drv/ntxn

32-bit device driver (x86).

/kernel/drv/amd64/ntxn

64-bit device driver (x86).

/kernel/drv/ntxn.conf

Configuration file.

See attributes(7) for descriptions of the following attributes:

ATTRIBUTE TYPE ATTRIBUTE VALUE
Architecture x86
Interface Stability Committed

streamio(4I), dlpi(4P), driver.conf(5), attributes(7), dladm(8), ndd(8), netstat(8)

Writing Device Drivers

STREAMS Programming Guide

Network Interfaces Programmer's Guide

October 13, 2008 OmniOS