SDPADM(8) Maintenance Commands and Procedures SDPADM(8)

sdpadm - SDP system configuration administration

/usr/sbin/sdpadm  status | enable | disable

The sdpadm command is used to display the system state of the Sockets Direct Protocol (SDP) protocol. The sdpadm command can optionally be used to set the state of the SDP protocol. See sdp(4D).

By default the SDP protocol is disabled on the system. It can be enabled by using sdpadm enable.

The following subcommands are supported:

status

Displays the system status of the SDP protocol

enable

Enables the SDP protocol

disable

Disables the SDP protocol

The required privileges to change the state of the SDP protocol are controlled by the network configuration policy. If a user does not have the correct privileges to set the SDP policy, sdpadm returns the current state of SDP without having changed the state.

See attributes(7) for descriptions of the following attributes:

ATTRIBUTE TYPE ATTRIBUTE VALUE
Interface Stability Uncommitted

sdp(4D), attributes(7)

Infiniband Specification Volume 1 (http://www.infinibandta.org)

December 22, 2008 OmniOS