AUDIT(1M) Maintenance Commands AUDIT(1M)

audit - control the behavior of the audit daemon

audit -n | -s | -t | -v

The audit command is the system administrator's interface to maintaining the audit daemon auditd(1M). The audit daemon can be stopped, started, or notified to reread the configuration, stored in smf(5) and managed using the auditconfig(1M) command.

-n
Notify the audit daemon to close the current audit file and open a new audit file in the current audit directory.

-s

Validates the audit service configuration and, if correct, notify the audit daemon to reread the audit configuration. If the audit daemon is not running, the audit daemon is started.

-t

Direct the audit daemon to close the current audit trail file, disable auditing, and die. Use -s to restart auditing.

-v

Validate the audit service configuration. At least one plugin must be active; if that plugin is audit_binfile then its p_dir attribute must contain at least one valid directory, and its p_minfree attribute must be between 0 and 100.

The audit command will exit with 0 upon success and a positive integer upon failure.

See attributes(5) for descriptions of the following attributes:

ATTRIBUTE TYPE ATTRIBUTE VALUE
Stability Evolving

praudit(1M), auditconfig(1M), audit(2), smf(5), attributes(5)

The -v option can be used in any zone, but the -t, -s, and -n options are valid only in local zones and, then, only if the perzone audit policy is set. See auditd(1M) and auditconfig(1M) for per-zone audit configuration.
March 6, 2017 OmniOS